Designed to meet NFPA low-frequency signaling requirements for unattended sleeping areas, the Autocall TrueAlarm 520Hz Sounder Base is a perfect solution for hospitality, education, and multi-occupancy residential applications. It offers an efficient, cost effective way to upgrade existing Autocall systems to NFPA compliance with minimal disruption.
Autocall photoelectric sensors help protect your people and operations while reducing the nuisance alarms that can cause disruption to your occupants and costly downtime for your business. Autocall TrueAlarm technology addresses a major causes of nuisance alarms — dirty sensors that result in overly sensitive devices.
Autocall TrueAlarm Multi-Sensor Devices combine the established performances of a TrueAlarm photoelectric smoke sensor with a TrueAlarm thermal sensor to provide both features in a single sensor/base assembly. Smoke and thermal activity are correlated to provide intelligent fire detection earlier than either activity alone.
Autocall TrueAlarm addressable heat sensors provide rate-compensated, fixed-temperature sensing, selectable with or without rate-of-rise temperature sensing. Due to its small thermal mass, the sensor accurately and quickly measures the local temperature for analysis at the control panel. Rate-of-rise temperature detection is selectable at the control panel. Fixed temperature sensing is independent of rate-of-rise sensing.
The Autocall CO Sensor Base is the ideal solution for detecting toxic CO gases in critical areas, such as residential properties, dormitories, hotels, nursing homes, and assisted living facilities. The CO sensor base has a replaceable CO element that can either work independently as a toxic gas detector or be combined with a photo or heat sensor to provide a method to reduce unnecessary alarms from common sources such as steam from showers, aerosols from personal care products, cooking materials, dust, and exhaust fumes.
The CO sensor base does not require a separate device to be mounted on the wall or ceiling. An Autocall smoke or heat sensor can plug into the base with the CO sensor element, saving mounting space as well as installation costs compared to using two independent units.
Autocall manual pull stations combine the familiar Autocall manual station housing with a compact communication module that is easily installed to satisfy demanding applications. Its integral individual addressable module (IAM) constantly monitors status and communicates changes to the connected control panel.
Autocall IDNet addressable modules provide addressability to conventional devices such as flow switches. Autocall products include a wide range of innovative addressable modules, including multi-point modules, modules that permit individual reporting from flow and tamper switches on the same circuit, and isolator modules that protect power wiring from short circuits and ground faults.
Autocall air-sampling smoke detectors are designed to detect smoke in challenging duct applications, as well as restricted areas, such as elevator shafts, electrical equipment rooms, hospital MRI rooms, and correctional facilities.
Beam detectors are used to provide open-area smoke detection in situations where it is either impractical or not cost-effective to use traditional point-type detectors or aspirating smoke detection. Some common applications include warehouses, atriums, convention centers, shopping malls, and sports arenas.
The Autocall Addressable Beam Detector provides enhanced command, control, configuration, and status/event reporting between the detector and the fire alarm control panel. Configuration, installation, diagnostics, service, and maintenance are simple and fast, saving time and money for contractors, installers, and building owners. It is compatible with Autocall 4100ES and 4010ES fire alarm control panels.